I am planning out my '31 coupe interior and trying to figure out the best sight lines for putting seams in the rear corners. Doesn't seem that I can make the entire quarter-back quarter out of one solid run. The back corners,at least at the upper 1/3 have the possibility of curves rather than 90 degree angles. I am planning on using ABS sheet s the backing.
So, if you've done, or seen this, where do the seams go? Three possibilities I have thought of would be -
1. At the rear of the quarter, jut before the bend/curve and then picking up the curve with the rear panel
2. Including the bend/curve with the rear quarter panel and having the seam at the edge of the rear window-the back panel just being flat.
3. Including the bend/curve with the rear quarter panel but ending where the curve hits the back panel-making the flat back panel extend all the wall across the back.
Advice,options and especially photos would be greatly appreciate. Thanks.
So, if you've done, or seen this, where do the seams go? Three possibilities I have thought of would be -
1. At the rear of the quarter, jut before the bend/curve and then picking up the curve with the rear panel
2. Including the bend/curve with the rear quarter panel and having the seam at the edge of the rear window-the back panel just being flat.
3. Including the bend/curve with the rear quarter panel but ending where the curve hits the back panel-making the flat back panel extend all the wall across the back.
Advice,options and especially photos would be greatly appreciate. Thanks.